Tools you will need:


1. needle nose pliers
2. flat head screw driver / knife
3. wire cutters / strippers
4. electrical tape / heat shrink tape
5. power wire about 3 Ft. of wire
6. wire connectors (16ga.)
7. 16 Gauge female connector
8. 30Amp or lesser fuse block


Now the first thing you want to do is hop into your car and pull the foglight cover off. To do this, I used a knife to pop the cover off and then used needle nose pliers to pull the plug out.






after you have the plug out, then cut / strip the red / yellow wire and connect your power wire using your wire cutters and strippers. place your 16 gauge connector over it and crimp it down snug. Wrap it in electrical tape or shrink tape like I did.


Now run your power wire to your fuse panel through the dash and put your fuseblock on the end the same way you connected the power wire. Add a 16Gauge female connector to the end of the wire using your crimpers and connect to the marked spot. Its right above your fuse panel.




Now turn your ignition on and press the foglight button. Should turn orange. Step outside and it should look similar to this: